Lovely Bones Necklace

Basic Instructions
String beads on beading wire as shown ending with the padlock and key toggle clasp, adding crimps in between the 6mm ridged spacer and 6/0 seed beads. A beaded accent is attached to the lock side of the clasp, crimps are placed in between the 6mm ridged spacer and 6/0 seed beads creating a loop with size 11/0 4221 seed beads. The necklace length is approximately 27 Inches with a 4 inch accent. Enjoy : ) tamarascottdesigns.com

Step by Step
Cut a 12 inch strip of the beading wire, string 25 (11/0 round-4221) seed beads and run (centered) through the padlock end of the clasp. Run both ends of the wire through a 6mm ridged spacer and salwag bead. Add beads to both ends of the accent wire as shown in the photo (remove the jump ring from the skeleton) and run back through the 6mm ridged spacer and 6/0 seed bead. String and center 67 salwag beads on the longer length of beading wire. String the beads on the left side as shown in the photo adding a crimp between the 6mm ridged spacer and 6/0 seed bead, run through the loop of the padlock end of the clasp, flat crimp and trim ends. Add remaining beads as shown in the photo on the right side inserting a crimp bead between the 6mm ridged spacer and 6/0 seed bead. Run the beading wire through the key end of the clasp, flat crimp and trim ends.

Basic Bead Stringing Knowledge Required.